Cutting speaker holes in door panels?

I used a jigsaw to cut the door metal behind my 10"s in my doors. Far from pretty but I don't really do anything pretty.
Good man! Thank you for the reply. My aftermarket speaker cutout diameter is 5.7 and the mounting hole mounting diameter is 6.2 so with just about 1/2 inch difference I can’t risk cutting into valuable door metal that I will need for proper speaker ring mounting integrity. 6.2 is coincidentally also the factory hole mounting diameter
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

You're probably right. I have two Taramps smart 3 amps and four 10 inch CT sounds tropo for bass. I'm actually going to only install one of the...
14
1K
For me.. a compact amp that wouldnt take up a whole lot of room and not real expensive for a 350-600 rms sub@2ohms or even 1 ohm load id look at...
19
805
Restarting the phone every 1-2 days is a plus too. My moms phone is useless by the third day of not restarting. As soon as it's restarted it's fine.
11
721
gain set well below "Normal" and base boost is off completely
15
2K

About this thread

marvinwillis

10+ year member
Senior VIP Member
Thread starter
marvinwillis
Joined
Location
Hinesville GA
Start date
Participants
Who Replied
Replies
18
Views
29,115
Last reply date
Last reply from
Popwarhomie
Screenshot 2024-03-07 184329.png

Doxquzme

    Mar 27, 2024
  • 0
  • 0
IMG_3075.jpeg

Daniel Lee

    Mar 27, 2024
  • 0
  • 0

Latest topics

Top