Hey I had recently gone from an Alpine S a60m powering my 8w7 to an Alpine X a90m and it worked great the first two startups but when I got in my car last time the sub or amp was not working correctly. I turned my car off and on again and heard a nasty crunching noise! The light on the top of the new amp was red so I checked the fuses on the block and the online fuse to the battery and they are all good. I made sure that the amplifier body was not damaged or grounding itself out on any stray wires or seat rails and it was all fine! I decided to record myself starting it up again and you can see it starts up but then crackles, turns red, then smokes. Hopefully the video attached correctly
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
The formula is Square Root of your target Wattage Multiplied by Ohms.
50Wx4Ohms=200. Square root of 200 is 14.14. So 15v AC is your target.
- Started by dalefavero20
- Amplifiers
The HU us likley 12-15 x 4 at best so yes, using an amp will be hugely beneficial, night and day. The HU us not going to drive a sub to any...
- Started by Paul Curtis
- General Car Audio
https://www.amazon.com/dp/B07DLC9M48/?tag=caraudiocom-20
- Started by Mr FaceCaser
- Amplifiers 2
Yep, that will mark the third iteration of teh X series. i figured that was in the loop as they have been running out of stock on the last...
- Started by MavRush
- General Car Audio
About this thread
