Amp problem ... Not putting out same power as before

97JeepTJ
10+ year member

Pimpin' Jeep ... :P
Hye guys. My buddies amp is a sony 1600p5,the 900x1 rms @ 2 ohm (14.4v) and its not pushing as hard as it was before when he got it. He had his gains set all the way and his LPF to the lowest, 50. his 40hz was all the way up. I don't know why its not as loud as it was before. I said to not put his gains up all the way but w/e.Could it have blown something? It still plays fine, jsut not with as much kick.

thanks

btw, its pushing 2 kicker comp vr 12's.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
3
1K
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
2
929
If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects...
15
2K
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
1
1K

About this thread

97JeepTJ

10+ year member
Pimpin' Jeep ... :P
Thread starter
97JeepTJ
Joined
Location
Boston, MA
Start date
Participants
Who Replied
Replies
1
Views
869
Last reply date
Last reply from
97JeepTJ
here.jpg

Popwarhomie

    Jul 23, 2024
  • 0
  • 0
20240720_091846.jpg

Bobbytwonames

    Jul 20, 2024
  • 0
  • 0

New threads

Top