Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Daisy chain front and rear speakers, or connect at the Amp?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="HardofWhoring" data-source="post: 8857404" data-attributes="member: 674149"><p>I'm really not trying to be rude, I'm just being straight with you. Didn't think you were stupid, or simple. Flat out you're just off on some really basic things, and trying to help you get this better, because I don't think you know as much about it as you think you do. Not trying to be rude, I just think there are other factors you are unaware of. </p><p></p><p></p><p></p><p>Doing this you lose front/rear, fader adjustability. & You're putting the bare minimum in the speakers, so that your sub maxes out at probably about 30-40% of what it is capable of if you put 500w RMS into that sub. If you're dead set on doing this, you go right ahead, but you're going to be missing out. I think you're close, it just seems like you're trying really hard, to do it half-ass. Good luck. </p><p></p><p>Yes you can measure it: </p><p>[MEDIA=youtube]gg2gl-fz2Qc[/MEDIA]</p><p>You should at least do this, and you will see what wattage your gain is set at.</p></blockquote><p></p>
[QUOTE="HardofWhoring, post: 8857404, member: 674149"] I'm really not trying to be rude, I'm just being straight with you. Didn't think you were stupid, or simple. Flat out you're just off on some really basic things, and trying to help you get this better, because I don't think you know as much about it as you think you do. Not trying to be rude, I just think there are other factors you are unaware of. Doing this you lose front/rear, fader adjustability. & You're putting the bare minimum in the speakers, so that your sub maxes out at probably about 30-40% of what it is capable of if you put 500w RMS into that sub. If you're dead set on doing this, you go right ahead, but you're going to be missing out. I think you're close, it just seems like you're trying really hard, to do it half-ass. Good luck. Yes you can measure it: [MEDIA=youtube]gg2gl-fz2Qc[/MEDIA] You should at least do this, and you will see what wattage your gain is set at. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Daisy chain front and rear speakers, or connect at the Amp?
Top
Menu
Home
Refresh