Recent content by xDATx

Hey, I'm looking for someone in SoCal about 50 miles who can design and build a ported enclosure for my Rockford Fosgate Punch HX2 RFD2112. thanks in Advance Dan

Hey all, I just installed an alpine PDX-1.600 along with my Pioneer Avic-D3. The alpine has a gain input selector from 0.1V – 1.0V or 1.0V – 8.0V. The pioneer Avic-D3 is rated at 2.2V pre-outs, I taught that I would have to set to 1.0V – 8.0V setting. When I did that with the sub level on...

SOLD!!!

thanks for walking me through this I was a bit rusty...lol

ok so if my speaker dis. cu ft. is 0.069 I subtract that from 1.58 Cu Ft leaving me with 1.51 Cu ft?

huh? lol so if i use 3/4 MDF i have to count for that? now i'm confused.

ok so 14" x 14" x 14" = 2744 divided by 1728 = 1.58 Cu Ft ?

So if i want to get 1.50 Cu Ft what would be an example in dimensions?

For Rockford Fosgate Punch HX2 RFD2212 I have attached the PDF manual for the specs If anyone can help I would greatly appreciate it. thanks Dan

I need it to be a smaller diameter, all the ones I find are 11-1/8" needs to be 10-13/16

Bump

Hey, I looking for someone in SoCal to make me a custom sealed box for my Rockford Fosgate Punch HX2. I have attached the JPEG file of the specs, I have the dual 4ohm. The reason I want it custom is I can't find a pre-made box that has 10-13/16 mounting diameter. If anyone also knows where I...

nobody is willing to make me a design?

I need a design.

I need builder...anyone? RF recommends: 1.0cu ft (28.32L) fb=35Hz 1 port - 3" X 13.25" FS(Hz) = 27 QTS = 0.347 VAS-cu ft (liter) = 0.95 (26.9) Xmax-inch(mm) = .55 (14) SPL (dB @ 1w/1m) = 83.4 Mounting Dia.-inch(mm) = 9-5/16 (237) Mounting Depth.-inch (mm) = 5-7/16 (138) Speaker...