Recent content by vehementSPL

pleasure doing business

message sent

so you will pay him 160 approx plus shipping. sheesh. I think I can get him more than that.... actually talking to friend now says he will do 200 plus shipping

Hey still have both of them for sale?. I just seen this and I might know somebody that needs both of them

And actually it doesn't have a lot of components for a 1.5kw amp. But does do more than rated so can't complain

Although his grammar was lacking... At least he is trying to research and learn... A big change compared to 95 percent of the idiots out there not on this forum... And a the 75 percent of the idiots on here that refuse to ask and just assume they are correct lol

Hmmm show me some proof... not calling you a liar but I think that somebody misinformed you. I am aware this happens in parts of the country. But in small towns, most cities have too much crime to worry about impounding your car for bass..... And tampa is one of the highest crime cities in the...

ttt

Well. I have used these amps and I must say they are kinda dirty... BUT actually aren't overrated... Actually do more than rated. If I remember correctly I tested mine at 930rms at 2.1 ohms at 11 volts after imp rise... It is rated at 950 rms at 2 ohms if I remember correctly ..... at that was...

ok... But i am talking about when you put a clamp on amp meter on the speaker output and switch it to dc amperage it will read. Some people are using this reading to determine how hard that particular amplifier is on speakers. I wondered if this was an accurate way to tell. Or if pretty much all...

Like the article says. I am far from an electronics expert and I have gotten a whiff of what I am starting to believe that could be a myth. What causes DC current through speaker outputs on amplifiers... Is it solely clipping the signal... Or do some amps naturally have high DC current levels...

I always used wood glue, But lately I have become more fond of heavy duty liquid nails. Seems plenty strong, much easier to apply and fills big gaps if you have any, and I also wipe it on the inside instead of silicon. Also anybody tried the PL or liquid nails Polyurethane I believe it is. It...

like frankie rio

I didn't know if it is because of space constraints or... I just always notice most clamshells that I see that are successful ported and non seem to be very narrow....Is there a technical reason they aren't more of a wide V instead of a narrow V like most of the succesful ones seem to be. Now...

fi car audio or re audio