Recent content by pcuaz21

It says it can run MAX POWER at 2ohms 1100 watts but I have no idea how much that is in "Boss's Watts RMS" terms so...

yeah I'm looking at a 400 watt RMS amp now. Now realizing that Boss might not be it :(

Well, I'd assume it's a 4 ohm load bc the sub says its 4ohm DVC

Too bad I found this out after buying...oh well :ROFLMAO:

Here is a picture of the port if it helps.

It is ported, it's just on the left side of the box which I didn't picture. Appreciate the help!

Yes, the sub is in a ported box with 1.3 cubic feet of volume inside. It is a Kicker 10" CompC sub in a 2008 honda civic si. It is located in the trunk facing rearwards with the amp on the side. I will mention that I have a LOC on top of the box from the factory sub wiring into RCA wiring.

The sub says it needs 250W RMS of power and the Boss R1100M has more than that

Hello all, I have a kicker 10" subwoofer 4 ohm DVC that I just installed with a Boss R1100M amplifier and it doesn't sound as good as I think it should. It works and it sounds decent but I know it can sound a lot better. I have 8 gauge wiring to it as well. Would appreciate some help!