Recent content by MrBananaMan

Gucci mane - aggressive and young Jeezy- put on both have very low bass notes in them. My subs barely push them out right now and it bugs me. I listen to a lot of metal - music that needs every part of the system to be doing its best to make a respectable overall sound. My subs poop on it too...

Well I guess that depends on what $400 gets me conpared to $900. What's the difference between the subs?

Have any resources on learning about dsp and subwoofers?

Is there a certain lineup of brands I should be looking at? Sundown, illusion... what else is there?

So morel aren't sounding that great. What about c12xl from illusion audio? Do any of you have experience with those? I also read that Peavy lowriders work well in a car as well.

I keep getting told that Sundown is not built for SQ. They're just your typical SPL subs geared a little less towards SPL and that Qts show it. Does anyone know anything about Ultimo Titanium subs? ULTIMO TITANIUM Subwoofer - Morel

I appreciate knowing that I could get one for 1500rms at least. *shrug*

From reading their description these do seem to be the kind of drivers I want. Extreme low end extension within small space and with low distortion. Are the z4 Rev 2 series new? A link to them isn't on their subwoofer page, though I found them it google.

Thanks for the suggestions guys. Any reason why you picked those? Also, how difficult is it to get a fairly flat curve down to 20hz these days? How much room is usually required?

I'm tired of my boomy, muddy kicker solo baric L7 12" x 2. I've heard a few good, clean subs and they've made me change my mind. SPL is out, sound quality is in. I'm redoing my subs and want the cleanest, flattest response I can get down to a solid 18-20hz. I'm willing to spend around $1,000...

Well I solved it, for anyone that read this. I used ONE set of wires to test both subs, and both subs worked independently with the amp. Then I tried the other set of wire and wala, they were sending the amp into protect mode. So i just tightened up the wires and screwed them in better, and...

My subwoofers and amp work fine together, until I was experimenting one day. The amp is mono, and I have two subs. They are wired with a positive and negative from each sub in their correct channels on the amp (2 positive wires in one channel, each leading to a different sub, and same for the...

No thanks!

Thanks for the help saturn! This will come in handy. To KOL: I'm strapped on cash so I'm trying to make due with what I have atm (college = little money). I'm starting to think pvc tubes are a better choice now because I can just seal my current slot port with wood and bend some tubes up for...

Oh sorry I read cu ft wrong in your post. The rest of the port will be On the outside of the box so I won't lose any cubed ft