Recent content by Blazin_Jason

Sure a lot of choices. Going with some PA either SQ or crescendo, 2 6.5's and 1 tweeter, would be a cheaper option. More to think about!

Nothing is installed yet, will be using existing equipment from my other s15 jimmy. More than likely the 2 FI BL 15's on 2 SAZ-1500d's. I know PA can get loud, but I would rather not have to tune too much. I have a premier p600ub that has some crossover I believe, but not a lot. I haven't...

Driving myself crazy trying to come to a decision on what to run for a front stage. Previously I had some older PG Octane R's off a sundown 100.2 in fg door pods. Was actually quite happy with them, but at times they seemed to struggle to keep up with the substage. Was running 2 15" BL's...

Does the block even have the casting for the mechanical fuel pump?

That looks great. That after buffing?

Did you have the awesome blinking led to let everyone know you have an alarm? I have an ultrasonic sensor in my truck and from playing around it seems to work quite well.

Thanks for sharing. Waiting for some vids. w00t A-Team and RipRock!

Go to a couple transmission shops and ask some questions. Other than that does it seem ok? Down shifts properly, sloppy or hard shifting?

I love DIY projects. Good work.

Nothing a couple trim panels couldn't hide eh :P

Truthfully you should be able to hit it with a hammer and it shouldn't chip. It can scratch though because it isn't hard because it's flexible. I would go back to them and ask what steps they took to do the wheels. They should have completely blasted them to a near white, a chemical...

2 most important steps are the prep and cure. What type of wheels, alum or steel, chrome or painted?

That stack of wire is sexy

That didn't look fun at all.

I had 2 group 34s on 3kw and it did fine. I wanted even a little more so that's why I went with the 31 in the rear.