First time installation

[Callingindogs]

I'll be doing my first install in the next month or so, doing part of my build this following week. In my rear deck I have two 6x9's that I want to wire 2ohm the speakers are 4ohms each svc, how can I wire them down to 2ohms? eventually i'll be wiring the 4 door speakers to 2ohms also, the door speakers are also 4ohm svc speakers. Any tips about installation would be much appreciated

[mylows10]

you cant ,unless they are 2 ohm speakers or you have 2 sets of 4 ohms speakers

[Callingindogs]

Could they be wired to 2ohms in a similar way two 4ohm subs could? and so the side doors are the only ones that could be wired down to 2ohms?

you cant ,unless they are 2 ohm speakers or you have 2 sets of 4 ohms speakers

[mylows10]

Could they be wired to 2ohms in a similar way two 4ohm subs could? and so the side doors are the only ones that could be wired down to 2ohms?

yes 2 4 ohm speakers in parallel will make 2 ohms

[Callingindogs]

So I could just use subwoofer wiring diagrams do wire the speakers down to 2ohms?

yes 2 4 ohm speakers in parallel will make 2 ohms

[mylows10]

So I could just use subwoofer wiring diagrams do wire the speakers down to 2ohms?

yes

[Callingindogs]

Actually that would just bridge it and it can't run at 2ohms bridge so nvm.. Does cdt sell 2ohm versions of their speakers?

yes

[mylows10]

none of the 6x9's are 2 ohm ,some of the 6.5 are tho

[Callingindogs]

es-6's or the hd62us's?

none of the 6x9's are 2 ohm ,some of the 6.5 are tho

[mylows10]

es-6's or the hd62us's?

hd 62 or the super hd 3.2 the es 6 mo mids are 2 ohm as well