500watts @2ohm or 500watts @4ohm

[dragnix]

I'm sending an old Zed autotek model 88 to be repaired (by zed) next week. It'll be my first taste of Mantz's stuff.

I just want a beastly 6ch. Active capable amp

[nationwide13]

not sure if op has made his decision yet, but if you have 2 4ohm subs, you can use a mono 2ohm amplifier, as long as you connect the subs in parallel, because that would drop your equivalent resistance to 2ohms

this is based on knowledge i have of physics, but heres a link to a wikipedia article that details what i have said in short

or not. i cant post links unfortunately

[darron016]

not sure if op has made his decision yet, but if you have 2 4ohm subs, you can use a mono 2ohm amplifier, as long as you connect the subs in parallel, because that would drop your equivalent resistance to 2ohms

this is based on knowledge i have of physics, but heres a link to a wikipedia article that details what i have said in short

or not. i cant post links unfortunately

So both subs would be at 2 ohms? Would that hit as hard as if they were both at 4ohms?

[ThatChevyGuy]

not sure if op has made his decision yet, but if you have 2 4ohm subs, you can use a mono 2ohm amplifier, as long as you connect the subs in parallel, because that would drop your equivalent resistance to 2ohms

this is based on knowledge i have of physics, but heres a link to a wikipedia article that details what i have said in short

or not. i cant post links unfortunately

His subs are Dvc 4ohm therefore on a mono amp it can be wired to 1 or 4 ohm