Went out there to start on my doors but it got darker alot faster then i expected. So far ive removed the factory cover off the door and removed all the sticky crap that was holding it on. I have a few questions now before i go further
1. Theres a wire for im guessing remote door unlocks even though i dont have one. Should i run the deader under this or over the top of it?
2. As for the holes, i want to go a easy route on them. Can i just cut out a bit of cardboard as bracing then put the deadner over it? Or just i just run the deadner over it and thats it?
3. How much of the inside of the door should i do? ima cover almost whole outer door, i have 25ft of 60mil audiotechnix and only 2 doors so ive got plenty.
4. Is it worth it to remove my brackets and cover them in deadner too?
Thanks guys! I ran outa day light so the pics are really dark, ima get on it early tomorrow and take some nice pics
Attachment 26529639Before----->AfterAttachment 26529640