Re: Is it safe?

Originally Posted by
1mtx1
i would lower the sub hz to 60 if u can and dont go max on the sub gain from your deck i would put it at + 2. if u go near lets say 40ish u will send a clip signal and if u start to play like this for sometime u will burn up your voice coils. what is your box tune to?
wtf are you talking about? That makes no sense. Don't give advice on stuff you do not understand.
OP, it is all about setting your gain correctly. You should out your gain to 0 on your amp and the sub level to 0 on the hu. Put in a good quality cd and turn it up until your speakers start to distort. Turn it down a few clicks. Then start turning up your gain on the sub amp gradually until you hear traces of sub distortion, then back the gain off a bit. BTW 80hz is where you should be at, do NOT set it to 60hz unless you have some serious midbass drivers that can play with authority that low which I am seriously doubting.
After this do not touch any of the settings, bass boost, gain, bass speaker setting etc. You will start clipping the sub if you do and this spells an early death for your sub.
04 Focus
4 sa-8
Solid f2500
JVC highs amp
Parts express drivers for high end
REFS
Sold to: RidnClean, thegreatestpenn, MrChow, Tuck05, whitem1ke88, moo_awn, Ray21, ben031681
Bought from: Mike465, Shinju (x3), azngotskills, Hazardous0388
Bookmarks