Help wiring CDT's
Hi again guys
I have a set of 3-way CDT componants and I have a question about wiring the crossovers.
There are 2 crossover for EACH side. There is a :
SatNet - midtweet crossover
SatSub - mid-bass crossover
Now, these are the connectors on each crossover:
The woofer, tweeter and midrange is straight foward. Just plug them in from each speaker. But how do you connect the crossovers? Do you go INPUT TO INPUT then use OUTPUT to my amp ?
If not, how do I connect them together and then to my amp?
MY SET-UP :
Head Unit :Pioneer Premier P660 w/ card remote
Subwoofers :4-12" Pioneer Premier TSW-1241 (Dual-Voice Coils)
Sub Amps :2 Zenon ASB-2200.1
Speaker Amp:Soundstream Rubicon 604 (4Ch.)
Rear Speak Fill:6x9 Infinity's
Front Speak:CDT (CL-641 3-Way Comps in custom kickpods)
Wires/Cables/Installation :2 runs of 0/1 guage, Knukonceptz RCA's, battery terminals, fuseholders, and 12,14 guage speaker wire and.. The Big 3
Sound deadening : 30sq.ft of Secondskin & 150 B-Quiet Extreme for doors etc., 200 sq.ft of Edead v.2 for floors and trunk
Box:6 Cu.Ft @32Hz