2 dvc 2ohm subs wired to a sundown?

[mr.michael]

hey i need some help real quick, i need to know the best way to wire my 2 dvc 2ohm subs to my sundown 3000d. they are auidopulse axis 15s. they are 2500rms. i do plan on getting another sundown but for now its beside the point. i was told by what i think is an idiot, that i could only wire them at 4 ohms? which is not gonna happen. anyways.... post away posters

[Ferendon]

Series-parallel? Would give you 2 Ohms.
Unless the amp is .5 Ohm-stable, then 2 Ohm is the lowest you'll get safely.

[mr.michael]

so that wouldnt be to bad eh? when the amp gives 1600 watts at 2 ohms eh?

[sexiewasd]

wiring options

[mr.michael]

wiring options

i have seen these, but if i have these subs at half ohms, does that mean my amp needs to be at half ohm to?

[sexiewasd]

The amp has no say in this matter.

[MisterGrubbs]

If you wire the subs to .5 ohm - that's what impedence your amplifier will see.

You can either run them at .5 or 2ohm.

At .5 the Sundown will be fine, as long as you're not a dickshit running it on a near stock electrical system.

[mr.michael]

The amp has no say in this matter.

hmmm, i c. thanks dude. so since i do have a .5 ohm stable amp i can run these at .5 ohm safely for daily? i dont drive much but still.

[mr.michael]

If you wire the subs to .5 ohm - that's what impedence your amplifier will see.

You can either run them at .5 or 2ohm.

At .5 the Sundown will be fine, as long as you're not a dickshit running it on a near stock electrical system.

hmm, ok yes. i am understanding. i am newish so this helps out. now, if i were to run my subs at 2 ohms each i belive they will see roughly 1600 watts each if im right. now if they are ran at .5 ohm each, what kind of power would they see? i dont wanna hurt my babys by giving em to much power? p.s. dickshits one of my favorite words...