voicecoil wiring options

[saltyreefguy]

question: regarding coils, ie. on the neg. push term. does continuity runs thru both pos. and neg. side of the coil?

[937DYTBOI]

if i had a dual 1 ohm sub can i break it down to .5 ohm or what would be the next lowest ohms setting i can run it at?

[squeak9798]

if i had a dual 1 ohm sub can i break it down to .5 ohm or what would be the next lowest ohms setting i can run it at?

A single DVC 1ohm per coil subwoofer can be ran at either .5ohm (coils in parallel) or 2ohm (coils in series).

[Ruffy]

quick question.

My Amp has 4 connections for the speakers.

+ + - -

Now my subs are 4ohm DVC wired down to 2ohm.
Do I just connect one sub to + - and the other to the other + - pair since it's a Class D amp and supposed to be bridged internally?

The manual is of no help.

[Lckmyblls]

yes one sub to each set of terminals (the reason they put 2 sets is for wiring ease they are really the same terminal) and the amp will see a 1 ohm load....

quick question.

My Amp has 4 connections for the speakers.

+ + - -

Now my subs are 4ohm DVC wired down to 2ohm.
Do I just connect one sub to + - and the other to the other + - pair since it's a Class D amp and supposed to be bridged internally?

The manual is of no help.

[nVRuckus]

LOL i think Hifonics has the manual for every amp but yours on their site.

[Fate710]

What are my options on Dual 1.4?

[KARLEON]

i think i covered this thread before and found nothing, but how do i wire together two quad 1 subs to get a final load of .5 ohms? diagram please, im a visual learner

[Frankensuby]

This may be a dumb question, but going from a Mono amp that is 2 ohm stable, how do I keep the system at 2 ohm? I see the pictures have 1 sub down to 1 ohm, but not at 2?

If it has to be brought down to 1 ohm, will the sub have more output?

I'm not good at the technicals.

~Levi

[Frankensuby]

Any help?

[xterra_on_22s]

didn't find it mentioned before, how would you wire 4-4ohm DVC subs @ .5 ohm ??

[xterra_on_22s]

didn't find it mentioned before, how would you wire 4-4ohm DVC subs @ .5 ohm ??

anyone???

[caseygw]

alright...lets say i have 4 speakers, all 4ohm, but im running them parallel off 2 channels. they get the total power at 2ohms as opposed to "splitting" it if they were in series, correct?

[springy101]

anyone???

wire 2 pairs of the dual 4 subs in series to get a 1 ohm load, then wire both pairs together in series for the .5 ohm load. ms paint coming in a minute, i always get my series/parallel confused to it might be backwards



so basically all pos and all neg are hooked together.

[xterra_on_22s]

thank you very much