so i just found out that the cd player my brother gave me only has 1 set of preamp outputs. i want to hook up two amps, how can i do this???
so i just found out that the cd player my brother gave me only has 1 set of preamp outputs. i want to hook up two amps, how can i do this???
daisy chain em, most amps have preouts
what if you had a sub amp and a front amp
DD 9515 (dual 1.5 Ohm)
American Bass VFL 200.1
Imigage Dynamics mids
CDT crossovers and tweeters
Alpine mrp F250 4 channel
Panasonic HU
Custom Built Box
145.5 DBs
Refs: Etznova, FLOSSINON24S, BigBowtie, DDshredder, Jeremydanza90, Btnhfan, Yunvme666
??? thats what i was assuming...
Very simple, most amps now have a set of RCA outputs that will send the same signal out to another amp, aka daisy changing. If this is not the case, you can get some splitters (1 male to 2 female) to give you (2) sets of outputs.
2004 Ford Crown Victoria
Alpine 9887 HU
Stock 5x7 door speakers
System is a work in progress.

one male to two female y-splitter found at radioshack...
http://www.radioshack.com/product/index.jsp?productId=2103862&cp=2032058.2032231.203 2280&pg=2&allCount=313&fbn=Cable+type%2FY-adapters&f=PAD%2FCable+Type%2FY-adapters&fbc=1&parentPage=family
you will need two of thoes. connect the male to the back of the deck, one on red.... one on white..... bam, two outputs.... run rcas accordingly.
keep in mind onboard x-over become useless because you dont want to send a hi-pass to your sub amp, or a low-pass to your highs amp....
References: (Sold To) - Blackbonnie, Ridinhi, BigEM (Bought From) - 95BlackGA, jonnybusa, 2002XLT, IamDeMan, kasimo420, SPL140.2, sundownz
MY REF PAGE
Car: 1993 Ford Crown Vic LX
HU: Panasonic CQ-C700U
Speaker Amp: Audiopipe AP2002
Sub Amp: Audiopipe AP18001
Sub: 15" Kicker L7
Box: 5.5 cu.ft. @ 35Hz w/ 68sq.in. of port
Front Speakers: Alpine Type R 5x7
Wiring: 1/0 Knu Wire, 4ga Stinger Wire, Knu Distribution Blocks, 1/0 Knu "Big Three", Fosgate RCAs
Accesories: AudioControl Epicenter
you can still do this i have done it before with a brutus and a kenwood
refs, djl , bonesninja, DB_DRAG_SPL ,headbussaboi is a scammerboom*u*like*dat,Redgp ,howdogg, korn4life,
i actually do not have any subs yet. i am using one amp to power my rear speakers and another to power my fronts.
so should i use "daisy chaining" or just get the y-adapters?
depends on the deck....some decks only have sub-out, if thats the case yoou either need amp with speaker level inputs or a loc for the fronts
^Yep, id do the daisy chain, all you need to buy is a short RCA cable which you probably have laying around your house.
1994 Toyota Camry
Pioneer DEHP6400BT
Rockford Fosgate 1050S
15" Obsidian Audio OA15
3.75 cuft, at 30 hz
1050wrms@4ohms
whats the model number on the cd player
just give the dj a break
where are they hiding...SEDONA
sony cdx-gt200
Bookmarks