Closed Thread
Results 1 to 2 of 2

Reload Thread: Is this a good setup?

  1. #1
    Moocow16's Avatar
    Moocow16 is offline Master of Puppets



    Join Date
    Aug 2002
    Location
    Detroit
    Age
    27
    Posts
    1,471
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Is this a good setup?

    I was thinking about getting 2 12" K series, but i don't know what amp i should use. Audiobahn A8001D? If i used this, how would i wire them so that i get a one ohm load? Thanks in advance.







  2. #2
    badazzDD's Avatar
    badazzDD is offline Senior VIP Member



    Join Date
    Sep 2002
    Location
    Texas
    Age
    29
    Posts
    273
    Post Thanks / Like
    Mentioned
    0 Post(s)
    to get an amp down to 1 ohm lod.. you either need 2 - 4 ohm dual voic coil subs or 2 - 2 ohm single voice coil subs.. the 4ohm DVC's - parallel each sub, them parallel both to the amp. . . the 2 ohm - parallel the 2 coils to the amp ... both will give a 1 ohm amp load.. but make sure the sub will hold that much power and them amp is 1 ohm stable




Closed Thread

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum