Closed Thread
Page 1 of 2 1 2 LastLast
Results 1 to 15 of 19

Reload Thread: Custom Av.2 15"

  1. #1
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist



    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Custom Av.2 15"

    Item(s) for Trade:
    Custom 15" Av.2 Subwoofer



    Item(s) Description/Condition:
    Cosmetically = 8/10
    Mechanically = 10/10

    Visually the motor has some small scratches from previous owner and the glue job could have been a bit prettier (this was my first custom build and first time using CA glue lol). Just a few areas received a little too much activator and caused the surface of the CA glue to bubble and whiten a bit. But all the joints are strong and I tested this guy for probably an hour in my car. It was free air and was hooked up to my Audioque 1200 at 1 ohm with no issues at all.

    It uses an Elemental Designs AV.2 motor with a 3" 4 layer copper D2 voice coil, TC Sounds 15" Ti Basket, stacked 10" TC spiders with dual sewn on leads, Sundown ZV.3 15" Cone/Surround, and a 5.9" CF dustcap.



    Looking to trade for:
    Let me know what you got. Really interested in JL13W7, JL Slash 1000/1, Sub motors/parts



    Item Pictures:





















    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D




  2. #2
    ciaonzo's Avatar
    ciaonzo is offline TheContinental



    Join Date
    Feb 2009
    Location
    WI
    Age
    39
    Posts
    9,234
    Post Thanks / Like
    Feedback Score
    25 (100%)
    Mentioned
    33 Post(s)

    Re: Custom Av.2 15"

    How tall is the winding in relation to the top plate?



    Quote Originally Posted by audioholic View Post
    Saying "clipping doesn't kill speakers" is a half-truth at best. Technically no, clipping itself does not hurt the speaker. But in clipping your amp, you can easily create a situation that WILL kill the speaker. Was the squared waveform the DIRECT cause of the failure? No. In the end, the answer is, always has been, and can only be... heat kills speakers. BUT, clipping increases heat generation, sometimes by a drastic amount. So to start a thread simply to state that clipping does not hurt speakers is, again, a half-truth at best.

  3. #3
    corollabass's Avatar
    corollabass is offline Member



    Join Date
    May 2013
    Location
    Aurora,CO
    Posts
    71
    Post Thanks / Like
    Feedback Score
    1 (100%)
    Mentioned
    0 Post(s)

    Re: Custom Av.2 15"

    pm sent




  4. #4
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist

    Threadstarter


    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by ciaonzo View Post
    How tall is the winding in relation to the top plate?
    WW is 2.29", Top Plate is 2". Amount of coil sticking above the top plate is ~.145". It's probably offset a little low though, because it's pretty hard to eye it and get it exactly .145" above the top plate lol.

    Quote Originally Posted by corollabass View Post
    pm sent
    Replied



    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D

  5. #5
    Join Date
    Nov 2011
    Location
    Dallas, Tx/Ada, Ok
    Age
    20
    Posts
    3,768
    Post Thanks / Like
    Feedback Score
    35 (100%)
    Mentioned
    32 Post(s)

    Re: Custom Av.2 15"

    trade for a JBL GTI MKII 15? similar to a w7, SQL monster sub




  6. #6
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist

    Threadstarter


    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by 04murdalanche View Post
    trade for a JBL GTI MKII 15? similar to a w7, SQL monster sub
    Very tempting, but no thanks. Trunks not big enough to fit a 15" the way I would like



    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D

  7. #7
    Join Date
    Nov 2011
    Location
    Dallas, Tx/Ada, Ok
    Age
    20
    Posts
    3,768
    Post Thanks / Like
    Feedback Score
    35 (100%)
    Mentioned
    32 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by *Ace* View Post
    Very tempting, but no thanks. Trunks not big enough to fit a 15" the way I would like
    If it helps any, they prefer really small enclosures, it's rated at 1k but since you'd be giving it the power of the AQ1200, it really wouldn't need much space at all.. Probably around 2.6 net




  8. #8
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist

    Threadstarter


    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by 04murdalanche View Post
    If it helps any, they prefer really small enclosures, it's rated at 1k but since you'd be giving it the power of the AQ1200, it really wouldn't need much space at all.. Probably around 2.6 net
    I have enough volume to work with, just not enough height in my trunk. Plus the JBL is dual 6 ohm so it would only see a 3 ohm load from my amplifier



    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D

  9. #9
    Join Date
    Nov 2011
    Location
    Dallas, Tx/Ada, Ok
    Age
    20
    Posts
    3,768
    Post Thanks / Like
    Feedback Score
    35 (100%)
    Mentioned
    32 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by *Ace* View Post
    I have enough volume to work with, just not enough height in my trunk. Plus the JBL is dual 6 ohm so it would only see a 3 ohm load from my amplifier
    Ahhh I gotcha, well if you did the baffle at, say a 45 degree angle it'd probably fit perfectly. No?(:


    Alpine PDX or a JL slash 1k would be nice




  10. #10
    Youngin's Avatar
    Youngin is offline Senior VIP Member



    Join Date
    Nov 2012
    Location
    louisiana
    Posts
    172
    Post Thanks / Like
    Feedback Score
    3 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    2 Super Shocker Extreme 12s built by hispls?



    03 Silverado
    2 DD 9515Gs
    Stetsom 5K2 E
    Looking for batts, mids, and mids amp
    260 Iraggi alt
    100 ah battery
    1 Run of 2/0 welding wire(pos and neg)
    Bought From: mylows10(x3), garretttt4, redrider, cyn, arkman54
    Traded With: Moler1129, cyn
    Sold To: Timmy13091, Spooney

  11. #11
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist

    Threadstarter


    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by 03silverado03 View Post
    2 Super Shocker Extreme 12s built by hispls?
    No thanks, appreciate the offer though



    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D

  12. #12
    Join Date
    Nov 2011
    Location
    Dallas, Tx/Ada, Ok
    Age
    20
    Posts
    3,768
    Post Thanks / Like
    Feedback Score
    35 (100%)
    Mentioned
    32 Post(s)

    Re: Custom Av.2 15"

    Really wish we could work something out I want this sub:/




  13. #13
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist

    Threadstarter


    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    Quote Originally Posted by 04murdalanche View Post
    Really wish we could work something out I want this sub:/
    This sub is also FS, buy it! lol



    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D

  14. #14
    *Ace*'s Avatar
    *Ace* is offline Subwooferologist

    Threadstarter


    Join Date
    Jun 2004
    Location
    Las Vegas, NV
    Posts
    562
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    1 Post(s)

    Re: Custom Av.2 15"

    **** double post...
    Last edited by *Ace*; 08-02-2013 at 01:18 AM. Reason: Double Post



    2011 Honda Civic Coupe
    Kenwood DDX419
    Image Dynamics CXS62 v.2 powered by an Audioque 200.2
    (2) Sundown SA 12" powered by an Audioque 1200D

  15. #15
    Full Tilt's Avatar
    Full Tilt is offline Bonafide MAFer



    Join Date
    Mar 2012
    Location
    Iowa
    Posts
    1,911
    Post Thanks / Like
    Feedback Score
    4 (100%)
    Mentioned
    14 Post(s)

    Re: Custom Av.2 15"

    I'd say it looks great for a first build, GLWS.





    Quote Originally Posted by T.I.K. View Post
    Careful, by those definitions Spider Monkey is a contributing member, I don't think he even knows what a subwoofer is.
    Quote Originally Posted by Truman View Post
    Thanks quackhead. Your the only person who agrees with me. Jesus Christ I have like 40 post and I've been called a ******* like 37 times

Closed Thread
Page 1 of 2 1 2 LastLast

Similar Threads

  1. Stryke AV-15
    By JonJT in forum Subwoofers
    Replies: 4
    Last Post: 12-27-2005, 11:15 PM
  2. AV 15's
    By fathom 7411 in forum Subwoofers
    Replies: 4
    Last Post: 03-28-2005, 06:43 PM
  3. My 'custom' XXX 15"
    By Randy Savage in forum General Discussion
    Replies: 21
    Last Post: 02-20-2005, 11:58 PM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may not post attachments
  • You may edit your posts
1e2 Forum