This amp- Kenwood X450-4
Bridged, 4 ohms: 60 watts x 2 chan. + 300 watts x 1 chan.
Mid range speakers on the 60 watt side,need a sub that you would use on the 300 side
was just gonna buy one, and then buy one box enclosure
open for any suggestions
This amp- Kenwood X450-4
Bridged, 4 ohms: 60 watts x 2 chan. + 300 watts x 1 chan.
Mid range speakers on the 60 watt side,need a sub that you would use on the 300 side
was just gonna buy one, and then buy one box enclosure
open for any suggestions

Dcon for sure.
REFS double 07, toxicity, liftednali, jes42, pieper88, mylows10, taylorfade, homegrown, vertex audio, gameovercca, radwilsons5803, juice+
HU: KDC-X994
Front stage: Phd FB 6.1PRO KIT, Active
Sub stage: 1st gen RE XXX 12" w/Fi recone
Highs Amp: Kenwood Excelon XR-4S
Lows Amp: Mmats D300hc
The Rest: AT 60 mil, Optima Redtop underhood and Yellowtop in trunk, Big 3 and front to rear +/- runs in Monster Cable 1/0
check out their pre-designed enclosures DCON Series Sub Woofer
If you need a custom built enclosure then check out the designers here in the vendor's secton.
thanx av , what about that enclosure? new thread ? lol
an enclosure should be designed with a few things in mind. vehicle type, amount of power, type of music played, etc. You are somewhat near these guys STARR MOUNTAIN SOUND - Home, or send a pm to @double 07 ;
HU: KDC-X994
Front stage: Phd FB 6.1PRO KIT, Active
Sub stage: 1st gen RE XXX 12" w/Fi recone
Highs Amp: Kenwood Excelon XR-4S
Lows Amp: Mmats D300hc
The Rest: AT 60 mil, Optima Redtop underhood and Yellowtop in trunk, Big 3 and front to rear +/- runs in Monster Cable 1/0
Oh, my bad. You will want the S4 then, because when you bridge those two channels of "amp B" on that amp it's 4ohm stable.
Best size will depend on how much space you have to lose for a box mostly. Have you taken measurements to see how much space you have exactly? If not, you should.
Bookmarks