osb for a box... smh.
Printable View
osb for a box... smh.
Wow. Sensitivity of 107???. Fs of 22hz? That can't be right. If it is these could be really decent.
wow if you didn't look at the specs your almost dead on it's 45hz-1.7khz according to the link.Quote:
Originally Posted by galacticmonkey
I'm sure the specs are right. It isn't a car audio sub. It's a pro audio woofer.
yea I hope so too I'm about to go look at the bay I'll post up a pic for everyone.Quote:
Originally Posted by justice66
That's what I was thinking when I was looking at them they seem for appropriate for concert/dj type use.Quote:
Originally Posted by galacticmonkey
Sorry douple post ten minutes apart... wierd
It's not right...I believe someone on diyma pulled the t/s for them. Something like low 30's FS and a ~96db sensitivity.Quote:
Originally Posted by Dirtrider4eva
T/S parameters, as measured by the big horn guys:
Fs: 31.61 Hz
Re: 5.59 ohms
Qms: 4.03
Qes: 0.38
Qts: 0.34
Vas: 9.69 cu. ft.
SPL: 95 dB 1W/1m
Power handling: 400 watts RMS/600 watts max
If Pyle sold just frames and 21" cones I'd buy just them for most of the asking price of those.
Ah, I was close! My memory isn't too bad after all.
[QUOTE=goingdef;8203109]yea I hope so too I'm about to go look at the bay I'll post up a pic for everyone.[/QUOTE.
Are you putting the pics up in this thread or a different one?
Sorry OP didn't mean to interupt your post. wanna sell the plyes?
[QUOTE=justice66;8203126]I'll make it's own going now, sorry op!Quote:
Originally Posted by goingdef
[QUOTE=goingdef;8203128]Roger that sorry OP! Cool build!Quote:
Originally Posted by justice66
Power at 4 ohm isn't cheap though. But the 4" coil is a plus. The high sen might make em get loud on lower power though....