turn the dmm to ohms, and each coii should read 4 ohms if they arnt blown
Alrite thanks. That helps alot now. Cuz i had no clue how to understand it at first
odd are its gonna look like this
your black lead goes to comm and your red lead goes to the V(ohm)mA
hook up the leads to the sub and make sure they are touching the metal part,no rubber or anything
turn the knob to the ohm section. Id put it on 200 or lower if you DMM reads that low
if its a cheaper DMM you might get some fluxuation.
Anyways, if you get anything over say 10 ohms, the sub is toast.. if it reads infinite ohms, the sub is toast
you might get 2.3 or 4.5 ohms,
DO NOT touch the sub or any part that may effect the reading.
set the sub on top of the box or somewhere that is not metal
CDT ES comp
Eclipse EA4200 amp on highs
TC Sounds LMS-r 12"
Refs = PapaGeno21, Goindef154, 92c1v1c, Disarmer, chemmins, 97maxima, kroid777, ithertz, basscort2009, hunterw, mar08052, appleyard, millimac247, jonny101abc, sundownz, cranberryyumyum, mig139, daboyfrumdabx, skateguy92, basebalz13.
Alrite i finally found a DMM in my garage. i hooked it up to my sub correctly and it reads fluctuating from 0.0 to 0.1 so doesnt that mean my voice coils are blown. if so is it possible to just buy new coils, and if i can would it be cheaper to buy new coils instead of buying a new sub
I would take it to a reputable dealer.. have them check it... if you are new to using a DMM they can be a little finickey... just to be sure I would have a pro check it...
2001 DB drag world finals S3-4
155.xx it was pretty loud for back in the day!
Originally Posted by [email protected]
Because Kicker kx's are rated a rms. rms and watts are not the same. So kicker kx2500.1 is x 2 = 5000.