Closed Thread
Results 1 to 3 of 3

Reload Thread: IDQ12V.3 power handling

  1. #1
    madmaxz's Avatar
    madmaxz is offline Senior VIP Member



    Join Date
    Feb 2009
    Location
    maryland
    Posts
    235
    Post Thanks / Like
    Mentioned
    0 Post(s)

    IDQ12V.3 power handling

    I just got another idq12v.3 from woofers running off a alpine MRD-M501 550wats at 2 ohm. is it possible this amp is putting out too much power for the idq. i have to have this amp set almost as low as it will go so the sub doesnt make noise when turned up. box is 1ft^3







  2. #2
    madmaxz's Avatar
    madmaxz is offline Senior VIP Member

    Threadstarter


    Join Date
    Feb 2009
    Location
    maryland
    Posts
    235
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: IDQ12V.3 power handling

    btw it sounds like its bottoming out but looking at it watching it it looks no where close to bottoming out. i have a third one on the way and a jl 1000/1. the plan was to run both in 1ft^3 each with the jl1000/1 at 4ohms.




  3. #3
    Hoodlum007's Avatar
    Hoodlum007 is offline CarAudio.com Veteran



    Join Date
    Apr 2003
    Location
    Reno Nv
    Posts
    2,070
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: IDQ12V.3 power handling

    I am giving mine about 400 to 500 watts each off an older PPI amp and they handle it with no problems at all. Check the wiring to make sure you have the pos and neg on correctly.




Closed Thread

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum