Closed Thread
Results 1 to 2 of 2

Reload Thread: how do i wire a memphis 500d to 2 jlw3 dual 4

  1. #1
    <Memphis amp help>'s Avatar
    <Memphis amp help> Guest



    how do i wire a memphis 500d to 2 jlw3 dual 4

    I have a memphis 500d amplifier. it is a mono block amp but has two speaker outputs(wired in paralell inside the amp). I need to know how to wire 2 jlw3's into a two ohm load so i can get the full power out of my amp. The amp is not one ohm capable. Can someone help me?







  2. #2
    Matt's Avatar
    Matt is offline Member



    Join Date
    Dec 2001
    Location
    Long Island NY
    Posts
    85
    Post Thanks / Like
    Mentioned
    1 Post(s)
    with 2 jlw3's lookin at 1.5 to 6 ohm. adding a 3rd jlw3 you can reach the 4 ohm load. check out

    <a href="http://www.jlaudio.com/subwoofers/pdfs/detailedpdfs/W3/10W3dB.pdf" target="_blank">http://www.jlaudio.com/subwoofers/pdfs/detailedpdfs/W3/10W3dB.pdf</a>

    on the bottom of the page is where they have the wiring configuration. Good Luck




Closed Thread

Similar Threads

  1. how can i wire a kx700.5 to 4 ohm dual VC comp vr's?
    By SatisTraction in forum Amplifiers
    Replies: 1
    Last Post: 05-25-2009, 12:37 PM
  2. is the memphis 500d amp any good
    By <memphis> in forum Subwoofers
    Replies: 7
    Last Post: 12-26-2004, 12:30 AM
  3. How Should I Wire My System?
    By 90cutlassciera in forum Subwoofers
    Replies: 1
    Last Post: 01-15-2002, 04:34 AM
  4. Memphis 500d
    By smp013 in forum Amplifiers
    Replies: 0
    Last Post: 12-29-2001, 11:14 AM
  5. how do i wire a memphis 500d to 2 jlw3 dual 2 ohm
    By <memphis 500d amp help> in forum Wiring, Electrical and Installation Help
    Replies: 2
    Last Post: 12-08-2001, 07:33 PM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts

1e2 Forum