Ok, first off, this is my first post here
The set up i have right now is ONLY temporary because i haven't had much time to change it since i installed it.
Im running 2 12" MTX 8500s with an absolute evd 2200 amp
(i have no idea why, but my amp has 2 channels instead of one)
How i currently have them set up is:
Input goes to crossover, which cuts off the lows at 200hz
goes to the amp.
amp sends individual signal to each sub.
Subs are 4 ohm dual coiled, in series, so each one is wired at 8 ohms.
Should i parallel the coils, then parallel both speakers and bridge the connection?
Or keep the signals separate, but parallel the coils?
Here's a pic of my set up