2 type r 1242d sub wiring

[^BBQ^]

no one is i the official type r thread.



i want to wire my subs into 1ohm (parrallel parallel) and i was wondering if that is what it looks like? i just wanted to be sure.

[bk12321]

http://www.crutchfieldadvisor.com/le...pedance=DVC4x2

[^BBQ^]

so bannana plugs - to - on each sub and + to + on each sub and then speaker wire to the outer - and + terminals?

[bk12321]

yes, going by the wiring diagram I would say u have it wrong

[^BBQ^]

so what i said is right but not the picture?

the picture isnt mine i just wanted to give a visual to show everyone what im talkin about

[bk12321]

in the picture the + and - are hooked together, its supposed to be both +'s hooked together and both -'s hooked together, if u want a 1 ohm load

i believe in that picture they are wired in a 4 ohm load

[^BBQ^]

thank you.
+1 street cred.

[Exploder 97]

yea,,, no need for plugs,,, just start from one sub,,, dual voice coil, start at one voice coil, postive to other postive on that voice coil,, same as negative... 1 sub done,,, now run the postive from the first sub over to the first postive on the 2 sub, then run the postive to the 2 voice coil. same as negative again, then on the last voice coil, run wires to your selected source

[grillman6000]

http://www.rockfordfosgate.com/rftech/woofer_wizard.asp