need someone to design a box for me

[Twistid]

2 12" Pioneer TS-W306C in a ported box , space isent much of an issue since its goin in the back of a subaru outback wagon

http://www.pioneerelectronics.com/pi...D1247-A_US.pdf

those are the specs on the subs for all info needed

[Harrison486]

I design boxes for $10 through paypal...

I wont be home till 2morrow morning though...

There are others

[Twistid]

ok well whats 10 bucks gonna get me? a normal ported design cus thats already included in the link i posted ...

[Twistid]

i just designed a very crude box ,



by "FRONT" and "BACK" i mean front is twords the seats and back is twords the end of the car...

where should i face the subs/ports? is this box any good?

[SSS 18734]

dont go by pioneer's box plans. I did and it turned out to be tuned to 45hz. Made the plans myself and it sounds pretty good though, even tuned that high.

[Twistid]

also the ports are gonna be circle ports not those rectangle ones, and what would i make my ports out of?

the calculator in the webpage thingy says a 3" diameter port x 6" long in that box is gonna be tuned to about 22 hz, thats good right?

[SSS 18734]

also the ports are gonna be circle ports not those rectangle ones, and what would i make my ports out of?

the calculator in the webpage thingy says a 3" diameter port x 6" long in that box is gonna be tuned to about 22 hz, thats good right?

22? that sounds awfully low for that sub. And use PVC pipe for ports. Worked great for me.

[Twistid]

so what should i tune it to then? thats why im posting on here! also are those box plans any good? could someone touch them up for me mayby or post there opinions?

[Twistid]

sorry i made a typo , here is the info , remember this is in 3.7 cubic feet
3" diameter x 6" long = 25 hz
3" diamter x 3.5" long = 30 hz
3" diameter x 2" = 35 hz

[Twistid]

in this box can i leave it so there is nothing cutting off the subs inside? or should i have a divider so each sub gets half the box and a port?

how do i find out how much space reinforcements are gonna take cus it said to compensate for the space? im prolly just gonna get little 3/4 mdf triangle pieces and use them in the middle of the box at all 4 corners, should i use more reinforcement?