i have 2 13w7s both dual 1.5 ohm got a good deal on them and need a little help wiring them up to a rockford fosgate t1500(new model)

Printable View

- 08-01-2013mulletman.zane2 13w7s needin advice
i have 2 13w7s both dual 1.5 ohm got a good deal on them and need a little help wiring them up to a rockford fosgate t1500(new model)

- 08-01-2013raptor727Re: 2 13w7s needin advice
http://a248.e.akamai.net/pix.crutchf...2-ohm_mono.jpg

with this you will end up with a 1.5 ohm load not enough to push both but it will do the trick - 08-01-2013raptor727Re: 2 13w7s needin advice
you other option is to wire to .375ohm I believe and your amp will not handle that

- 08-01-2013des343Re: 2 13w7s needin advice
- 08-01-2013cx-7heavenRe: 2 13w7s needin advice
With the subs wired to 1.5 ohms like is described in the link, your subs will sound just fine. Don't buy into the whole "underpowering" nonsense. Your amp will push somewhere in the neighborhood of 1500 watts to those two subs which is more than enough to get them to get very loud. This is assuming that it is the bdcp amp. If it were an older one, it would do slightly less(1200-1400) at that 1.5 ohm load, and you probably would not be able to hear the difference.

- 08-01-2013shauncox26Re: 2 13w7s needin advice
Just traded my 1500 birthsheet said it did 1763 at m @14.4v and 1900ish at 1 ohm. So i would say yes it is right there at the sweet spot at the 1.5 ohm load.

- 08-01-2013kramer_212Re: 2 13w7s needin advice
- 08-01-2013kramer_212Re: 2 13w7s needin advice
- 08-01-2013maddogRe: 2 13w7s needin advice
I looked up the specs on the new rockford power1500 and...

Rated Power

(RMS Continuous Power):

1000 Watts x 1 @ 4-Ohm

1500 Watts x 1 @ 2-Ohm

1500 Watts x 1 @ 1-Ohm

so wired to 1.5, you should get the 1500 max rating and I agree with the other guy, it will be loud.