Custom Nightshade v1.5
Item(s) for Sale:
15" Nightshade v1, D1, upgraded.
NS v1 motor, NS v2 coil (spacer added for longer coil), Zv3 spiders (dual leads), new basket to fit the larger spiders, aluminum pole piece, extra large terminals.
I ran these for a week off of an SAZ 3k at .5 on each sub and they took it fine. I did not run them even long enough to break them in before starting my wall build.
I built 3 of these alike and used them for about a week before I got my Crossfires and pulled these to start that build. This is still like new and really stiff. Last one left of the three.
I did not refinish the motor, so it has some scratches on the bottom.
$300 plus shipping
Shipping and Miscellaneous Item Information:
approx. 65lbs. from 98375
I am in the Seattle area and have access to all major shippers so calculate with your favorite and I will use them. Will be very well packed in one of the wood framed boxes I received my Crossfires in.
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).
03' MERCURY MOUNTAINEER XR / HU:Kenwood DDX-719/Mid/high:Front-Image dynamics ctx65cs / Rear- Image dynamics ctx65cs/Mid/high ampssax-200.4 Sub:4X Crossfire XSv2 15's in a c-pillar wallSub Amps:AB 1100.1/Electrical: 7 x XS 3100's, Mechman 340a, lots of Shok wire.
ALL IN CONSTANT STATE OF UPGRADE155.3 sealed on the dash and gaining.
Bought from: Ridnclean
Sold to: jr711