This is for a single ID 10"...1.3 cubes net....32hz.......sub up/port back..
http://i1079.photobucket.com/albums/...226_180225.jpg
http://i1079.photobucket.com/albums/...226_183545.jpg
http://i1079.photobucket.com/albums/...226_183615.jpg
Printable View
This is for a single ID 10"...1.3 cubes net....32hz.......sub up/port back..
http://i1079.photobucket.com/albums/...226_180225.jpg
http://i1079.photobucket.com/albums/...226_183545.jpg
http://i1079.photobucket.com/albums/...226_183615.jpg
sigh, too bad you dont accept trades. lol
Matt
Sub cutout got a little skar on it...dad blamed round over bit bearing came flying off.......LOL.......
http://i1079.photobucket.com/albums/...226_195333.jpg
http://i1079.photobucket.com/albums/...226_195339.jpg
http://i1079.photobucket.com/albums/...226_195345.jpg
Nice!
ryobi bits are pretty good. but diablo is the way to go!
Matt
i laughed too, and i got a sig out of it so props to you man!
Matt
Almost finished with her....
http://i1079.photobucket.com/albums/...227_121616.jpg
http://i1079.photobucket.com/albums/...227_121624.jpg
---------- Post added at 12:49 PM ---------- Previous post was at 12:49 PM ----------
Almost finished with her....
http://i1079.photobucket.com/albums/...227_121616.jpg
http://i1079.photobucket.com/albums/...227_121624.jpg
This looks awesome! I honestly thought I was going to be a few weeks down on the waiting due to the holiday, haha.
Tracking number sent....leaving out tomorrow........Thanks