Re: Connection Speaker to amp
you need separate rcas, power, ground, and turn on wire ran to the f300. you also need a turn on wire for the autotek.
you can daisy chain the turn on wires and use a distribution block to run power wire from the battery to it and then out to your 2 amps. I'd use no smaller than 4 ga from the battery to the distribution block. if your hu does not have sub out rcas, use the rca out on the f300 to get signal to autotek.
Last edited by DukeNut; 02-20-2011 at 12:26 PM.
jshak07, photocrazy8, DARKHART, dadon, enzowho