I just realized that if i mount these selenium 6w4p's in my doors i will have to relocate my tweets. So i was looking for different places for an easy install and i found the defroster cover panel. Its the length of the dash and has plenty of room for tweets. Not much mounting depth though. Small format tweets should fit nicely. My question is...... is it ok to use 2 tweets per side? I am thinking of running (2) 4 ohm tweets per side for a total of 8 ohms per side , and then the pair of 8 ohm mids in the doors. Ran active on (2) Sony XM-5540's Bridged. Any thoughts on this setup?