Mpyre Mids, EQ Screamers, and (2)Sundown 125.2's

[SPLluminator]

How would you wire it? I figure i would wire comps to one amp, tweets to the other. But how do i set my crossover point?

[here to buy]

set the screamers to 3k,

and the mypres to 3k or a lil higher, they start to cutoff pretty low though.

on the tweeter amp, highpass at 3k.

on the mypre amp, lowpass 3k

[SPLluminator]

Thats all there is to it? Or woudl i have mids on flat?

[here to buy]

u could send all the freqs to the mids, but you shouldnt
you will run into phase and cancellation issues and sound a lil muddy, thats what the tweets are for

especially with the mypres, they cutoff low.

all mids beam at a certain frequency point, and cutoff steep around there

[SPLluminator]

Ok so set the cutoff around 80?

[here to buy]

nahhhhh set the lowpass cutoff of the mypres to 3000hz,
you can subsonic them low, as they handle the lows as well as any mids ive heard.
you can set them to 50 or 63 just fine.

[RAM_Designs]

Bandpass the mids from ~60hz to somewhere between 2k-3k. Then just high pass the tweets in the 2k-3k area, and tinker with it to find what sounds best to you.

[SPLluminator]

Ok thanks soo much for your help HERETOBUY and RYANM923. Its appreciated.