Closed Thread
Results 1 to 2 of 2

Reload Thread: Have you ever think about modify your crossover?

  1. #1
    paulyang's Avatar
    paulyang is offline Junior Member



    Join Date
    Feb 2007
    Location
    Indiana
    Posts
    5
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Have you ever think about modify your crossover?

    I have DLS UP5 compenents.....i just take a look at its corssover......

    if i replace better capacitors and resistors....will that give me better performance??

    or.....i should replace capacitor on my AMP first...!?

    my set up:

    Audi Stock Head Unit (i do not plan to replace this one....0.0'')

    AMP: Xtant 604

    Speaker components: DLS UP5

    Sub: Image Dynamics IDQ10


    thank you!!







  2. #2
    mvw2's Avatar
    mvw2 is offline Senior VIP Member



    Join Date
    Mar 2007
    Location
    Rochester, MN
    Posts
    481
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: Have you ever think about modify your crossover?

    It's an option if you don't like the x-over point or slope used. You could build a new one to cross a little lower or higher and run a steeper slope or similar. I doubt you'll find much of a difference just changing to higher quality components alone. The real difference will be in what x-over point and slopes you use. As well, if you're this interested in modifying your x-over, you might as well consider just going active and get full control over it. There are some pretty affordable high end HUs available that are up to the task. It's just a matter of if you want to swap out your stock HU...if you even can.
    Last edited by mvw2; 03-14-2007 at 04:34 PM.




Closed Thread

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum