Building components with A/D/S 335iS xovers

[ultimate157]

I'm going to be building some components for my DD with these cheap A/D/S crossovers I got from parts express. Since they came with ZERO documentation, I've got a quick question on how to wire these beasts:

Why are there two inputs?

I'm looking to use the AA PolyMids with these tweets:

http://www.partsexpress.com/pe/showd...number=264-578

What are your thoughts?

[ultimate157]

anybody

[entropie]

If you have the crossover's i have then there should be four total inputs or two pair, two positve and two negative labeled IN+ and IN-. both the positives are toward the center with the negatives out from them. right?

if so, according to the manual, if you're not bi-amping or bi-wiring as they call it, you are to use the inputs closer to the tweeter outputs or the T+ and T-. the other outs are obviously for the woofer W+ and W-. now i never tried the other two inputs, i just followed what the diagram in the manual showed. i couldn't tell you if it was bad or not.

not to steal your thread but i am looking to sell the a/d/s/ 335is comps i have. i upgraded to 6.5's and am looking to give them to someone who will appreciate them or they go on ebay.

good luck with the hook up.

[ultimate157]

Thanks for the information. I do have those crossovers.