So I just got a set of 6.5 Diamond D661s, this being my first set of components. 200w max. I also have an old Profile California amp laying around that I would like to use with these components. The specs on this amp are as follows:
100 watts RMS x 2 at 4 ohms
300 watts x 1 in bridged mode
150 watts x 2 at 2 ohms
I'm used to wiring subs, but with components I'm a little confused as to how I'm supposed to wire them. The mids are 4ohm svc obviously. How should I wire these to get max power out of them without damage?
The way I see it, if I just wire one channel to each crossover, each side will get 100w (theoretically), correct?