MurderMat Promo Launch GIVEAWAY

[popeyeortiz]

Startign a new build!
1970 Monte Carlo Super Sport
Forest Green
Gonna be putting a Digital Designs 9512 dual 2 ohm with a Hifonics BRZ 2500
I have a little 10 pioneer and damm that trunk rattles since car is all metal -__-
Would enjoy having some sound deadner!!

[schrummy]

2002 Grand Pirx GT
System:
(2) DC Audio XL M2 12s
(1) TREO Engineering 6.1
Trunk install for metering outside of the car (MidWestSPL Extreme Trunk Division) Does a 149 on the dash and a 136 outside the car.
I would use the product to sound deaden the roof of my vehicle.... the car is maroon in color...

[Bettr n' Revrse]

79 Single Cab short bed F-150... Doing an active install so my doors need to be sealed and deadened for mid bass response and to reduce road/engine noise... Plus some for the C-10 next to it since the bored and stroked 454 is quite loud

Here are some more pics... It will be Scan Speak drivers and a custom 8" sub which will be active off of an Eclipse CD7100 and Zed built Warrior amps...

Amps...


Deck...


One of the mids and the doors Ill be working with...

[Toone]

I drive a 2005 ford escape Daily driver/bassrace but in the middle of a rebuild for next season at the moment. My quick goals for deadening are to stop my flex problems which are obvious in this video of my last setup Seen here. My hatch and roof need murder mat like no other lol.

[adas]

few more days guys!

[redrider]

[Jaguar]

Good luck.

[DreDay256]

Anxiously waiting ...

[jteske88]

end is close guys, good luck to everyone.

[hellz]

2003 Hummer H2
37 inch mud tires that make some good road noise
Single 10 inch sub, but looking to change that single to dual SA-10's

Would like to reduce road noise right away, and get my vehicle ready for a good system

[redrider]

Anxiously waiting ...

^^^^^^

what he said........

[tprj82]

2012 silverado tx edition


a set of these are on order



either going to be 4 18's in a wall or 6 15's in a blowthru, trying to convince the gf its wiser to wall then cut sheet metal, going to need to deaden before the wall goes in

looks like this is going to be 6 15'a or 8 12's in a 4th order, finalizing the design, back seats already out, which i cant believe i did to a truck with 223 miles on it lol, so much road noise with that rear seat out, hopefully going to be removing the door panels shortly to install the components would love to deaden the doors while i have them off

[redrider]

^^^^^

baller status

[jteske88]

bump end is near guys, good luck

[basshead7890]

95 Honda Accord SSA Xcon 18, saz1500, saz100.4, lanzar opti mids
My goals are to get of rid rattles and be able to really enjoy the bass especially the higher bass notes.
Mainly I want to redo the my front doors which I put peal n' seal on there, will never use it again, it has started to melt and peal off. Also my rear doors and roof doesn't have any thing on them.