Premier 860 anyone using the network mode ?

[danny_isr]

my current setup is 4 ch (2+2)amp that running the front doors(2way-6.5") and tweeters.
4ch (2+1) amp that running rear speakers(3way-6x9) and a sub(12").

I’m using the Premier 860 , in regular mode.
and i was wondering how this "pro network" mode is . will it sounds any better ?
what the benefit if there is any....?

How you guys recommends me to connect the speakers in this mode.
i mean for example :

highs - tweeters
mid - doors and rears
low- sub
or

highs - tweeters and doors
mid - rears
low - sub

or

highs - tweeters
mid-doors
low - rears + sub

or any other configuration.

thanks Danny

[B&R Innovation2]

i have a 940mp and I use the regular mode. I went otu of my way and hooked everything up independently under network mode and the SQ way possilby a bit better and seperation was on the spot. Any good tuning in regular mode will give you the same results. Wiring it regular leaves more options with less amps.

[crash813]

Better seperation, the ability to run all active, greater flexibility to customize your freq., greater xo slopes (36 on sub, 24 on all others)

Most common setup:
highs - tweets
mid - midrange/midbass
low - sub

or 3 way
highs - tweet
mid - midrange
low - midbass/sub

Its great for tweaking a system or playing with different components. There is definately a learning curve with getting the most out of the system using it though.