I just ordered a DB drive pd200.1 off of Audiosavings, and it will be powering 2 sundown SA-12's at 1 ohm, in a fourth order designed by Buck.
To support the amp I have an 80 ah Deka and 2 33 ah no-name batteries I got off ebay (I got them tested and they are nothing special but they are ok) along with an 800 CCA Optima Redtop under the hood. My car has a 120 amp alt from the factory and all my wiring will be 1/0 CCA (XS power and Knukonceptz).
My front stage is a pair of Image Dynamics CX64 v2 mid-range/ mid-bass drivers matched with a pair of Hertz HT 25 tweeters. They are off an Aura rpm 2300 2-channel amp. Right now the are passively crossed over using a pair of Swiss audio cross overs. I plan to get another amp for my tweeters and run active. The crossovers cut out if more than 100 watts are run through them. I feel as though the cross overs are the weakest part of my front stage.
This will be put in a 2001 Chrysler Sebring. I took the rear seats out to back room for the fourth order. Also I have 25 ft of Audio Technix deadener in the trunk and on the doors, and I plan to put more in especially on the roof.
So does everything look ok? does any one have any helpful suggestions? thoughts, opinions?