Closed Thread
Results 1 to 1 of 1

Reload Thread: framing out a window.....

  1. #1
    azone's Avatar
    azone is offline Junior Member



    Join Date
    Mar 2004
    Location
    Los Angeles
    Posts
    3
    Post Thanks / Like
    Mentioned
    0 Post(s)

    framing out a window.....

    I did a search to see if I could get any good hits on this but I didn't find much details.
    I'm wondering what's a good way to frame out a window, such as an small acrylic window in front of an equalizer or amp rack. Specifically I have an amp rack I built that goes in the the spare wheel well. The carpeted wood "floor" of the trunk will go over the top of the amprack sub-frame so it's flush with the bottom of the trunk. I wanted to route out a rectangular window so you could see the amps. I'm wondering what's a good way to frame the wood cutout against the acrylic. I'm thinking the acrylic window would either be flush with the rest of the floor or recessed 1/4" or so. I'm just not sure how to interface the cutout to the acrylic. I think this makes sense!...any ideas would be great
    Last edited by azone; 03-26-2004 at 12:37 AM.







Closed Thread

Similar Threads

  1. Replies: 18
    Last Post: 11-06-2003, 07:25 PM
  2. Plexi amp window
    By PeaveyBassist in forum Enclosure Design & Construction Help
    Replies: 8
    Last Post: 10-21-2003, 09:06 PM
  3. window vs. speaker
    By rayne8504 in forum General Discussion
    Replies: 3
    Last Post: 07-16-2003, 08:09 AM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts

1e2 Forum