User Tag List

Closed Thread
Results 1 to 7 of 7

Reload Thread: Need some info and help.

  1. #1
    killaakuma's Avatar
    killaakuma is offline Junior Member



    Join Date
    May 2012
    Location
    richmond vs
    Posts
    6
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Need some info and help.

    Ok this is what I have and I'm trying to find out if this sub and amp configuration are a good match. I am going with 2 12" and there going in a dual chamber ported box. I have already destroyed a set of subs but that's because I over powered them. There going to be wired at 2ohm that's the best rateing for sub and amp. So please someone help me. Is this good or bad?







  2. #2
    trumpet's Avatar
    trumpet is offline Supporting Vendor trumpet is a Supporting Member of the forum!

    trumpet is a Supporting Vendor of the forum!

    Join Date
    Jan 2011
    Location
    Langdon, ND
    Age
    33
    Posts
    4,716
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Need some info and help.

    Without knowing anything about your setup I can guess that you destroyed your old subs because you had the gain maxed on the amp. Overpowering doesn't kill subs, it's heat over time that fries voice coils. If you drove the subs to the point of breaking glue joints that's a little different, but either way you need to figure out why you wrecked subs before it happens again. Wiring for a safe Ohm load on the amp is a good start.




    Small town service, family owned and operated. See our new mobile friendly online store at store.513electronics.com
    Home to CDT Audio's Systems Design Specialist
    Perfect Fit Speaker Kits
    Our CDT Audio dealer store, Clarion,_JBL,_Pioneer,_DB Drive,_Metra,_T-Spec
    My system: Pioneer AVH-4000NEX, JBL MS-8, Clarion XC6610, JBL GTO-751EZ, CDT 6.7"/4"/1.1" in the front doors, 4"/1.1" center channel, Audiomobile Elite 2212 12" ported, Clarion SRG-1622R rear fill

  3. #3
    killaakuma's Avatar
    killaakuma is offline Junior Member

    Threadstarter


    Join Date
    May 2012
    Location
    richmond vs
    Posts
    6
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Need some info and help.

    Sorry don't wana repost so edited this out




  4. #4
    killaakuma's Avatar
    killaakuma is offline Junior Member

    Threadstarter


    Join Date
    May 2012
    Location
    richmond vs
    Posts
    6
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Need some info and help.

    Repost again srry guys I'm doin this fron the cell




  5. #5
    killaakuma's Avatar
    killaakuma is offline Junior Member

    Threadstarter


    Join Date
    May 2012
    Location
    richmond vs
    Posts
    6
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Need some info and help.

    12" Dual 2 Ohm M3 MOJO Series Subwoofer Power Handling: Peak: 2000 watts RMS: 1000 watts Impedance: Dual 2 ohm Kevlar reinforced paper cone High-density foam surround Custom-cast vented "M" Basket Bolt-through modular motor for easy repair Orange finish Dual 2 ohm voice coils 3" Black anodized aluminum 4-layer voice coil former 228oz. Magnet Sensitivity: 90 dB. This is the best info I can find about the subs.
    Class D
    Power (watts) Mono 2500 @ 2 Ohms
    Remote Bass Control Yes
    Length (in., cm) 27/1/2, 69.7
    Common to all Models Height: 2-1/8", 5.4cm Width: 9-5/8", 24.4cm Frequency Response: 25-200Hz (ZX300.1 25-20kHz), +0/-1dB Input Sensitivity: High Level 250mV-10V, Low Level 125mV-5V Signal-to-Noise Ratio: >95dB, a-weighted, re: rated power Active Crossover: 24dB/octave, variable 50Hz-200Hz (ZX300.1 fixed at 80Hz), low pass only 24dB/octave high-pass subsonic filter fixed @ 25Hz KICKEQ™ Boost: Variable to +18dB (ZX300.1 selectable +12dB), centered @ 40Hz




  6. #6
    brodeisel's Avatar
    brodeisel is offline The Cool Newb



    Join Date
    Jun 2011
    Location
    iowa
    Posts
    4,319
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Need some info and help.

    Are you sure you have the subs wired at 2 ohms?



    Bought from- pjc, boomsday, El Weenie, Sacsking, BassinBuick, Kangaroux
    Sold to- Mast240,

  7. #7
    killaakuma's Avatar
    killaakuma is offline Junior Member

    Threadstarter


    Join Date
    May 2012
    Location
    richmond vs
    Posts
    6
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Re: Need some info and help.

    Yea I'm sure. I know all that stuff and I'm pretty sure I know these subs will habdle the amp well but I'm looking for second opinions. I'm not noobish at doing installs or on audio I just have never worked with memphis audio so I know nothing more then what I have heard or read. But I am no expert so I always like to hear what other people have to say about a product.




Closed Thread

Similar Threads

  1. Jus need some suggestions and help
    By Jwright0291 in forum General Discussion
    Replies: 3
    Last Post: 05-26-2010, 01:27 PM
  2. I need some info on Us Amps USA-425 and VL-200
    By Vwbuskid in forum Amplifiers
    Replies: 3
    Last Post: 02-08-2010, 09:08 AM
  3. Replies: 11
    Last Post: 01-29-2009, 09:52 AM
  4. need some box and wiring help...
    By SteveV14 in forum Subwoofers
    Replies: 5
    Last Post: 01-13-2009, 10:04 PM
  5. making a box, need some info on the 0615" L5. help
    By reed dollaz in forum General Discussion
    Replies: 3
    Last Post: 11-12-2007, 07:34 PM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum