Closed Thread
Results 1 to 3 of 3

Reload Thread: need help with box specs for Alpine Type-R

  1. #1
    herrrerrera's Avatar
    herrrerrera is offline Junior Member



    Join Date
    Dec 2009
    Location
    pomona, ca
    Posts
    27
    Post Thanks / Like
    Mentioned
    0 Post(s)

    need help with box specs for Alpine Type-R

    Looking to have a box built for one 10" Alpine type-R 4ohm dual voice coil woofer.
    I have 2 spec sheets i was thinking. before i have it built, just want to see if you guys agree with these specs, or if you would change anything. Just want to get the full potential out of the woofer as i can. i will be using a Rockford Fosgate t500-1 db amp. thanks



    this one is a little bigger, lower freq. tuned to about 36hz








  2. #2
    d-REW's Avatar
    d-REW is offline tuTWENTY



    Join Date
    Jul 2008
    Location
    denver COLORADO
    Posts
    1,121
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: need help with box specs for Alpine Type-R

    both are kinda large for what the sub wants its around .6 to 1.3 IIRC and with 1500 on tap it can handle a smaller encloure just fine i did 2 alpine type r's in 2.18 cubes after disp with aq2200



    Refs: Rashaddd, SotoGrip, ProjectPechkin, Walled Taurus, Just303, tenbux1970, tmasco, Worstenemy45, blazron22z

  3. #3
    herrrerrera's Avatar
    herrrerrera is offline Junior Member

    Threadstarter


    Join Date
    Dec 2009
    Location
    pomona, ca
    Posts
    27
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: need help with box specs for Alpine Type-R

    thanks for input
    i have been told the specs for the woofer was .82 to 1.15 so i had a sealed box built 2 years ago for 2 10" type-r with .68 box and it sounds great at low volume, but sounds horrid if i want to crank it up a bit.
    Back then i just wanted the smallest box i could get away with, and have it sound as sharp and clean as possible, but now i'm just after a box that will let the sub shine to it's full potential, sealed or ported..
    the amp isn't powerfull enough for both woofers, and i dont have money to buy another amp, so i'm just going to build a box for one woofer

    Care to throw out some specs that you would use if you built a box for one type-r?




Closed Thread

Similar Threads

  1. Question about box built to specs for 12" Alpine Type-R's
    By Mills561 in forum Enclosure Design & Construction Help
    Replies: 1
    Last Post: 04-25-2010, 11:06 AM
  2. Alpine type R 15 should I build the box to there specs ?
    By Jeepjones85 in forum Enclosure Design & Construction Help
    Replies: 10
    Last Post: 11-13-2008, 02:11 PM
  3. Alpine Type R Specs
    By hojna15 in forum Subwoofers
    Replies: 2
    Last Post: 04-18-2007, 08:21 PM
  4. Best type R box specs!
    By HardCoreSound in forum Subwoofers
    Replies: 17
    Last Post: 03-02-2007, 02:32 PM
  5. Specs for 05 Type R
    By amermuscle15 in forum General Discussion
    Replies: 1
    Last Post: 01-12-2006, 06:05 PM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts
1e2 Forum