Another VS Thread - AudioQue vs Memphis, help!
I got .7^ft per sub to work with, sealed
I got a maximum mounting depth of 5.5"
And I got 150x2 at 4ohm, or 225x2 at 2ohms to work with amp wise
So Question is...
Memphis PR10's - 5.25"(I think it is?) Mounting depth, which gives me very little breathing room in there
AudioQue LW10's - 4.75" Mounting Depth
So the question is, which one do I go with? I don't necessarily want to rattle my truck to pieces lol, so I'm trying to get a clean sound, but that gets low. It's going in an 02 Quad Cab Dodge 1500, full four door.
Also - If I were to go with the AudioQue LW12, it only has a 5.25" Mounting Depth - would .7^ft be entirely too small for that woofer? And would it play louder/as clear as the 10, even at the same power with same airspace?
Lots to answer, just answer parts of it if you're too lazy, but if possible give me all the help you can.
*Note* - Keep in mind I'm poor and that two PR10's can be had at about 150 shipped vs about 220 shipped on the two AudioQues...
Educational session for you retards of the forum:Use there when referring to a place, whether concrete or more abstract. No kove, I will not come over there. Use their to indicate possession. Members of this forum have lost their minds. Remember that they're is a contraction of the words they and are. They're all idiots!
References(Some of them):SteveyHustle, PepsiFiend69, SubNoize05, BushJ311, Mrray13, Hintzyboy, dbubble, 528hz, Twisted_0912, RKPsk8er
Ebay: 35+ 100% Feedback Paypal: 14+ Verified