a quick sound deadening question?
hi guys. well i got some edead for the floor/spare tire area for my car and some damplifier for the doors, since i heard damplifier works much better than edead where gravity is a factor. anyway, i may be double-layering the mat in some areas, if i have lots left over, BUT when applying the first layer and applying the cut stripes,
should i place the stripes butt against each other, or overlap the pieces slightly??
of course , the second layer would go on over top as well after.
MY SET-UP :
Head Unit :Pioneer Premier P660 w/ card remote
Subwoofers :4-12" Pioneer Premier TSW-1241 (Dual-Voice Coils)
Sub Amps :2 Zenon ASB-2200.1
Speaker Amp:Soundstream Rubicon 604 (4Ch.)
Rear Speak Fill:6x9 Infinity's
Front Speak:CDT (CL-641 3-Way Comps in custom kickpods)
Wires/Cables/Installation :2 runs of 0/1 guage, Knukonceptz RCA's, battery terminals, fuseholders, and 12,14 guage speaker wire and.. The Big 3
Sound deadening : 30sq.ft of Secondskin & 150 B-Quiet Extreme for doors etc., 200 sq.ft of Edead v.2 for floors and trunk
Box:6 Cu.Ft @32Hz