RE box calculator

[jungstah]

are the specs given from this calculator accurate enough to go by?
I am gonna build a box for my 2 SA's soon, hoping to fit all the cuts on 1 sheet of MDF...

if not, what's wrong with it?

*flame suit on*

[UnderFire]

Never used RE, but Torres' calculator is great, has all of the measurements and displacements right there on the screen, very user friendly.

[nkrell11]

RE calculator is notoriously inaccurate I use torres and it works great.

[Montana]

I used RE for my first box I ever made when I first got my head into car audio, I was running around with a "3.5" cube box with a "35"hz port on my two 12 SAs.

Turned out that box with the given sizes was 5.5 cubes@43Hz.

>_>

Still have that box, makes for a hood umbrella holder, those 11 inch holes they do.

[jungstah]

Thanks to everyone for their input! I just dled the tores calculator off a thread from the SMD forums (google lol).

I wonder if i could get the guy at home depot to make all my cuts HAHAH...it would **** if i made a slanted cut on accident.

[Montana]

Thanks to everyone for their input! I just dled the tores calculator off a thread from the SMD forums (google lol).

I wonder if i could get the guy at home depot to make all my cuts HAHAH...it would **** if i made a slanted cut on accident.

You can, it'll cost you.

However, there is no fun in that.

Building enclosures is quiet the experience, half of the fun if you will.

[Spooney]

Thanks to everyone for their input! I just dled the tores calculator off a thread from the SMD forums (google lol).

I wonder if i could get the guy at home depot to make all my cuts HAHAH...it would **** if i made a slanted cut on accident.

Don't let home depot make those cuts unless you absolutely have to. I have had very mixed results with that . Far more failures than successes when letting them do the cutting. What I thought would save me time ended up being a huge pain in the ****. I have them rip it down to a few manageable sheets and then do all the real cutting at home.

[jungstah]

Don't let home depot make those cuts unless you absolutely have to. I have had very mixed results with that . Far more failures than successes when letting them do the cutting. What I thought would save me time ended up being a huge pain in the ****. I have them rip it down to a few manageable sheets and then do all the real cutting at home.

yeah, i actually have a table saw at home, but its really small and would be hard to chop a full sheet of MDF up.

10 in. 15 Amp Table Saw-RTS10 at The Home Depot

[Boomsday]

torres is slightly off from my calculations.

[mazdakid]

I used RE for my first box I ever made when I first got my head into car audio, I was running around with a "3.5" cube box with a "35"hz port on my two 12 SAs.

Turned out that box with the given sizes was 5.5 cubes@43Hz.

>_>

Still have that box, makes for a hood umbrella holder, those 11 inch holes they do.

You did something wrong then. Its not off by that much.