Closed Thread
Results 1 to 3 of 3

Reload Thread: new box build

  1. #1
    frogcase2002's Avatar
    frogcase2002 is offline CarAudio.com Elite



    Join Date
    Dec 2011
    Location
    hamilton, ohio
    Posts
    533
    Post Thanks / Like
    Mentioned
    23 Post(s)

    new box build

    alright, i just built a box (not sealed up or anything, just put together) and im wanting to take it appart and put it together inside my trunk because it wont go in if its all together,,,,, so im just wanting to no whos done this and the best way because there is only going to be 2 or 3 inches inbetween the box and the top and bottom of the box so i no my drill wont fit there,, its for my zcon 15, its 4.5 cf tuned to 32 hz.......................................

    also im going to be fiberglassing all the inside of the box and wanting to see if anyone has some tips on getting rid of the smell of the fg resien, because my van im working on a wall in smells really strong and its been like a week since iv done any fiberglassing in it and im not wanting my car to be smelling like that cause its my everyday driver







  2. #2
    frogcase2002's Avatar
    frogcase2002 is offline CarAudio.com Elite

    Threadstarter


    Join Date
    Dec 2011
    Location
    hamilton, ohio
    Posts
    533
    Post Thanks / Like
    Mentioned
    23 Post(s)

    Re: new box build

    so really, noone has built a box inside there trunk




  3. #3
    snyderd758's Avatar
    snyderd758 is offline Senior VIP Member



    Join Date
    Feb 2011
    Location
    emigrant gap, ca
    Posts
    235
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Re: new box build

    Sounds like you have you work cut out for you. I would probably try to get ahold of a small right angle drill. The best screws i have used for constructing a box are the t25 style they dont strip which will probably be an issue. maybe lay down a blanket or piece of plastic you dont care about so you can at least use some glue on the joints. then construct the box from front to back and before you put The back on lay in all your glass. One other route is maybe take out your back seat and rear baffle and work around the rear bracing to get as many screws in it as possible.




  4. Thanks frogcase2002 thanked for this post
Closed Thread

Similar Threads

  1. my new box build, 2.3 cu ft tuned to 32hz re se 12"
    By stalephotograph in forum Enclosure Design & Construction Help
    Replies: 9
    Last Post: 09-28-2010, 07:22 PM
  2. new box build...
    By RumbleNTheTrunk in forum Enclosure Design & Construction Help
    Replies: 10
    Last Post: 06-23-2006, 01:13 PM
  3. new box build
    By caliece in forum Enclosure Design & Construction Help
    Replies: 1
    Last Post: 04-24-2006, 11:31 PM
  4. New box build-Pics!
    By jalverson in forum Enclosure Design & Construction Help
    Replies: 8
    Last Post: 01-24-2006, 09:13 AM
  5. New Box Building Tips
    By nosaj070 in forum Enclosure Design & Construction Help
    Replies: 7
    Last Post: 02-04-2004, 01:01 AM

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts

1e2 Forum