Closed Thread
Results 1 to 1 of 1

Reload Thread: Need Help with box design

  1. #1
    rallystang's Avatar
    rallystang is offline Junior Member



    Join Date
    Nov 2011
    Location
    Colorado
    Posts
    2
    Post Thanks / Like
    Mentioned
    0 Post(s)

    Need Help with box design

    I had good luck with having someone from this site design me a box in the past, and need some more help with my new ride. I have a center console I'm building for a new Escalade. I am not good at box design and could use a hand. Will pay a "Reputable" designer for design prior to delivery, name your price. The box is about 2.0 SQFT if you take into account the sub displacement and the .2 cuft cupholders. Sub is down firing, with port exit down firing as well.

    Music goals:
    Strictly SQ. Mostly Hip Hop, but needs to sound good for whatever is played. Tuning HZ is your call. The TI loves to go "Deep". Overexcursion is a concern as well being down firing and due to the nature of this sub(has happened in previous slot box on certain notes).


    Sub Titanium Eclipse 2 Ohms
    Amp MTX Jackhammer 600 RMS
    Material 3/4 MDF and 3/4 Polycarb


    INSIDE DIAMETER DIMENSIONS
    Height 13.75
    Width 12.5
    Depth 24

    Sub specs
    RE - 3.1 ohm (each VC)
    FS - 27hz
    qts - .30
    vas - 3.2 ft2
    spl - 89db
    qes - .32
    qms - 5.0
    sd - 490 cm2
    xmax - 38mm
    woofer displacement - .19 ft2

    Front and possibly rear of box are going to be polycarb. I am happy with 3/4 MDF. Final box will have music controller with LED's, and be wrapped in Gator and Leather. Will send designer a youtube link once finished. The front of the box is slightly angled back(14 to 1 pitch), hence depth measurement was given as average depth.
    Last edited by rallystang; 11-03-2011 at 01:02 AM. Reason: SO MANY "FORBIDDEN WORD" ERRORS!







Closed Thread

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may post attachments
  • You may edit your posts

1e2 Forum