what you think about this box design

[subzero]

[galacticmonkey]

Wayyyy too much port for music.

[subzero]

its a burp box.

[Moble Enclosurs]

I can tell you it is good enough for RE standards only..not always yours. Does this "calculator" account for anything with the driver considered?

[bhsdriller]

^ it doesn't

[hispls]

link is broken

[Moble Enclosurs]

^ it doesn't

If that's true, then it would be tough to know if the design is capable of doing what you(OP) want it to without those considerations.

[subzero]

ok, I need a burp box. I already built this box. 34.5wide x 14 H x 18 deep. I can redo the front baffel and port. I just need to know parms' here is the link to the sub specs.

http://www.soundstream.com/manuals/2...fer-manual.pdf

I have 2 12's on up to 10Kw. The car peaks around 45-47 I was thinking about building a burp box tuned to 45hz

[Moble Enclosurs]

ok, I need a burp box. I already built this box. 34.5wide x 14 H x 18 deep. I can redo the front baffel and port. I just need to know parms' here is the link to the sub specs.

http://www.soundstream.com/manuals/2...fer-manual.pdf

I have 2 12's on up to 10Kw. The car peaks around 45-47 I was thinking about building a burp box tuned to 45hz

Sounds great. Ill do some crunching for you in the late morning. I know just by looking at the specs and putting together some parameters off hand, that these particular driver would like a 46.57Hz tuning rather than a 45Hz tuning for spl. So, do you want me to use that or 45?

[subzero]

use whatever you think would sounds best. Thanks alot .

[Moble Enclosurs]

No problem. I can't design the box for you without a purchase, but I can get you some basic info for it.....and only as a basis.....volume, tuning, and port size. But if you want me to design it also, let me know. I can add vehicle gain, proper phase correlation with port and driver baffle direction, increased efficiency, proper driver control, etc....the works. If not, the recommended will give you a good start.