Need a box design for 2 SA-8s!

[swollen_cu]

Hey guys I need a box design for 2 SA-8s! I want it to be ~1.5 cubes tuned to 32 hz. I would love it if you could do it for free, but If you want a donation, that'll work.

I'll be powering the subs off of an AQ1200D @ 1 ohm.

[T.I.K.]

OH MY GOD, PICK ME!

lol

[Popwarhomie]

Why 1.75?? I run a 1.85 with my 2 and my AQ1200d. Im building a new one right now thats 1.2 cubes. Jacob now suggest .5-.6 each sub.

[swollen_cu]

^ Haha SHOW ME THE WAY!

---------- Post added at 02:41 PM ---------- Previous post was at 02:40 PM ----------

Why 1.75?? I run a 1.85 with my 2 and my AQ1200d. Im building a new one right now thats 1.2 cubes. Jacob now suggest .5-.6 each sub.

hmmmm OK i'll settle with 1.5 right now. OP edited..

I want music all around to sound good not just get loud .. That's why I want a slightly bigger box to make it sound deeper.

What don't you like about the 1.85^3 box?

[T.I.K.]

i'm assuming you want something with a similar layout?

[swollen_cu]

i'm assuming you want something with a similar layout?

I want an L slotted ported box. That's too fancy. Something easy to make.

And I need the width to be under 30"

[T.I.K.]

It's 30x12x17, btw

Feel free to send me 100000000000 dollars, my paypal is geordaneichhorn@gmail.com

[Phoenix Risen]

one i did a while ago. .75 each at 33. not trying to steal business, but figured i would show ya.

[T.I.K.]

one i did a while ago. .75 each at 33. not trying to steal business, but figured i would show ya.

Y U TRY TO TAKE MY CUSTOMERS?!


i didn't want any money, I wasn't doing anything important so i drew it up

i love center port boxes but they look like they're a little harder to make

[Phoenix Risen]

its not too bad. you just have to split the port width in half and finish the length that the center run didnt cover on both sides.

you also have to remember to account for wood displacement, especially when tuning low with long ports.

[T.I.K.]

its not too bad. you just have to split the port width in half and finish the length that the center run didnt cover on both sides.

you also have to remember to account for wood displacement, especially when tuning low with long ports.

What I always do is I figure out the cubes, draw that box, and add the port on behind the box, then all you have to account for is driver displacement and and bracing you choose to add.

[RAM_Designs]

I've done a few in the 1.25-1.5ft^3 range with a 32-35hz tuning...seems to work well.

[swollen_cu]

I've done a few in the 1.25-1.5ft^3 range with a 32-35hz tuning...seems to work well.

Yeah I emailed BUCK about making me a box and he's gonna be making one to spec for me.

---------- Post added at 01:11 PM ---------- Previous post was at 01:10 PM ----------

It's 30x12x17, btw

Feel free to send me 100000000000 dollars, my paypal is geordaneichhorn@gmail.com

Haha I'll keep this design in mind... I have BUCK making me a box design right now.