Can someone put this into SketchUp?

[rival904]

And also let me know if thats enough port area for a 12in RE XXX, sub firing forward, port firing up.

Thanks

[dappa5]

which side is bottom and where do you want port??
what size sub??

[rival904]

The "Height 1" is the bottom, think of a wedge box for a pickup truck. Its for a 12in RE XXX, new style

[dappa5]

what's the mounting depth and where do you want the port /?

[rival904]

Mounting depth is 12.75

And I want the port on the "height 2"

[dappa5]

there is no port but specify where you want and i'll model it
in not sure there is enuff mounting depth though

[dappa5]

there is not enuff mounting depth are these your max max dims??

[rival904]

No, my max demensions are

H - 25.5
Wdth - 58
Max Depth at the bottom - 16.5
Max depth at top - 10

[dappa5]

No, my max demensions are

H - 25.5
Wdth - 58
Max Depth at the bottom - 16.5
Max depth at top - 10

well its that ratio of 10 top and 16 bottom thats killin you you should try a trunkated style sub need to lay down a bit more

[rival904]

What you mean?

I thought about doing a long, skinny box, thats shallow, and just invert the sub and the ports.

What you think?

[MakeshiftAudio]

That sketchup isn't even right for what the table says.

Anyways, you can't just calculate a box volume then plug it into the port calculator, because the port itself has displacement, and will decrease box volume. UNLESS you use an external port.

[rival904]

Right, I understand that the tuning will be off by a little bit.

Either way, I just want to fit this big *** sub in my truck lol

[dappa5]

[quote=rival904;6477054]The "Height 1" is the bottom, think of a wedge box for a pickup truck. Its for a 12in RE XXX, new style
]
so why is it wrong?

[dappa5]

it may be possible with those dims but the sub wil be @ bottom of face not centered

[rival904]

With my idea, I could center it between the seats.